ACCURATE WAY TO LOAD A BOLT IN THE WORLD
HANDS DOWN!!
2 TYPES OF TENSIONING
1 HYDRAULIC TENSIONERS = (MODULAR TENSIONING) : THE TENSIONER IS PLACED OVER THE STANDARD NUT, AND PULLS "TENSIONS" THE THREADED BOLT TO THE EXACT CLAMP LOAD NEEDED, THEN THE ORIGINAL NUT HOLDS THE FORCE, AND THE TOOL IS REMOVED.
2 HYDRAULIC NUTS = THE TOOL STAYS WITH THE THREADED BOLT. THE HYDRAULIC NUT PULLS THE THREADED BOLT, THEN A COLLAR SCREWS DOWN TO HOLD THE FORCE, THEN THE HYDRAULIC PRESSURE IS RELEASED. THE TOOL ACTS AS THE NUT.
TENSIONING APPLIES CLAMPING FORCE BY DIRECTLY STRETCHING THE BOLT THRU HYDRAULIC PRESSURE, AND ELIMINATES TURNING THE NUT, ELIMINATES GALLING. EXTREMELY ACCURATE. INSTALLATION IS SUPER FAST, AND REMOVAL IS GUARANTEED TO BE EASIER.
THERE IS NEVER ANY TURNING OF THE NUT UNDER LOAD!!
WHEN ITS CRITICAL, AND IT NEEDS TO GET DONE FAST
TENSIONING IS KNOWN WORLD WIDE AS THE PREFERRED METHOD
ACCURATE BOLT LOAD WITHIN 2%
CLICK HER TO DOWNLOAD THE TENSIONING APPLICATION DATA SHEET
 |
 |
| HYDRAULIC NUTS | LOOK INSIDE OF A HYDRAULIC NUT! |
 |
 |
| MODULAR TENSIONING ON A REACTOR | LOOK INSIDE A HYDRAULIC TENSIONER (MODULAR)!! |
 |
 |
| WINDMILL BASE BOLT TENSIONERS SHOWN WITH OPTIONAL GEAR DRIVE |
PLATE HEAT EXCHANGER BOLT TENSIONERS SIMULTANEOUSLY CLOSE YOUR EXCHANGER WITH THE PUSH OF ONE BUTTON CAN BE DONE ACHIVED IN MINUTES WITH TITAN TRI-NUTS THEY REQUIRE ZERO TURNING OF NUTS! |
 |
 |
| THE HYDRA-BOLT HYDRAULIC
BOLTS THESE ARE JUST LIKE THE HYDRAULIC NUT BUT OFFER A ENGINEERED BOLT IN ADDITION TO THE NUT |
THE HYDRA-CELL FASTERNERS A HYDRAULIC NUT THAT APPLIES TENSILE LOAD TO BOLTS OR STUDS AND SIMULTANEOUSLY LOCKS ITSELF ONTO THE THREAD. NO NEED TO TURN DOWN THE COLLAR AFTER ITS TENSIONED |
 |
 |
| HYDRA-JACK TURBINE TENSIONING
HYDRAULIC HALF-JOINT TENSIONERS ESPECIALLY DESIGNED FOR HALF JOINT TURBINE TENSIONING. LIGHT, EASY, AND FAST. |
HYDRA-CELL CLAMP NUT REPLACES CONVERTIONAL TORQUE-LOADED THREADED NUTS TO MAKE SHAFT TENSIONING SIMPLE. |
 |
|
 |
 |
| GAS TURBINE ROTOR THROUGH BOLT TENSIONERS OFFERING THE FASTEST OPERATION, AND MOST EVEN COMPRESSION OF THE ROTOR STACK. |
TITAN AUTO-TENSIONERS ARE USED IN THE NOSE CONE OF A WIND TURBINE WHERE SPACE IN LIMITED, THEY HAVE A ELECTRIC MOTOR ATTACHED TO THE TENSIONER TO AUTOMATICALLY RUN DOWN THE NUT. |
WHAT IS THE PROBLEM WITH THIS PICTURE?
TORCHED OFF THREADS!!
IF YOUR NUTS LOOK LIKE - THE NUTS ON THE RIGHT HAND SIDE,
CALL US IMMEDIATLY!
WE CAN REPLACE THEM WITH AN FASTER, MORE ACCURATE SOLUTION
THAT DOES NOT INVOLVE CUTTING OFF STUDS!
RECEIVE A QUOTE
